ArchaeoFusion User's Manual
1. Introduction
2. Overview of ArchaeoFusion
3. Installation Instructions
3.1 Minimum Requirements
3.2 Installation
4. Detailed User Guide
4.1 Main Window
4.1.1 Mapping Surfaces
4.1.2 Using the Survey List
4.1.3 Using the Operation Stack
4.1.4 Survey Display Controls
4.2 Main Menu
4.2.1 File Menu
4.2.2 Edit Menu
4.2.3 Operations Menu
4.2.4 Macros Menu
4.2.5 Surface Menu
4.2.6 Survey Menu
4.2.7 Tools Menu
4.2.8 Help Menu
4.3 Merge/Break Up Surveys
4.4 Survey Tool
4.4.1 Load File Dialog
4.4.2 Using the Tile Editor
4.4.3 Using the Survey Tool Controls
4.4.4 Using the Basic Tab
4.4.5 Usig the GPR Tab
4.5 GPR Loader
4.5.1 Load GPR Profiles
4.5.2 Bandpass Filter
4.5.3 Fiduciary Mark Adjust
4.5.4 Auto Level
4.5.5 Clip Soundings
4.5.6 Remove Average Sounding
4.5.7 Gain Adjust
4.5.8 Depth Adjust
4.5.9 Save 3D GPR Tile
4.6 Operatons
4.6.1 Destagger
4.6.2 Resample
4.6.3 Clip
4.6.4 Despike
4.6.5 Detrend
4.6.6 Zero MeanTraverse
4.6.7 Mean Profile Filter
4.6.8 Range Match
4.6.9 Warp
4.6.10 Balance
4.6.11 2D Fourier Filter
4.6.12 1D Fourier Filter
4.6.13 Calculator
4.6.14 Linear
4.6.15 Nonlinear
4.6.16 Spatial
4.6.17 Smooth
4.6.18 Fill
4.6.19 Reclassify
4.6.20 Edge
4.6.21 Standardize
4.6.22 PCA
4.6.23 K Means
4.6.24 No Op
To properly display this page you need a browser with JavaScript support.
< Previous page
4.6.24 No Op
No Op is an operation that is sometimes used as a place holder or initialization step. Its inclusion in the current version is for consistency with older version and its use is not recommended.
Last Updated June 15, 2011
